Memorex MC1003 - Manual (Page 8)

7
INSTALLATION
MOUNTING THE UNIT ON
THE BASE
To use this unit with the
supplied base, simply slide
the hole on the rear of the
unit into the hook on the
base and gently push it
backwards so it snaps in
place as shown in figure 1.
REMOVING THE UNIT
FROM THE BASE
To remove unit from base,
simply press in on the tab
located at the bottom of the
base and lift up the unit as
shown in figure 2.
USING THE HANGING
CORD (No Figure):
Use the Hanging Cord to
hang the unit on an already
installed hook, nail, etc.
When using the Hanging
cord, also use the Wall
Adapter for extra support.
SPLASH RESISTANT: DO NOT use this unit under direct
water flow. This unit is splash resistant, meaning it can
withstand small splashes of water.
Hook
Hole
Figure 2
Figure 1
MC1003.QXD 3/3/03 9:56 AM Page 7