Philips Magnavox MC132EMG/17 - Manual (Page 14)

14 Setting TV Channels
• The TV/VCR distinguishes
between standard TV channels
and Cable TV channels.
• If you activate AUTO CH PRO-
GRAMMING when no antenna
or Cable TV signal is connected
to the TV/VCR’s ANT(enna) jack,
NO TV SIGNALS will appear on
the display after completion of
channel scanning.
• To select Cable TV channels high-
er than 99, press the +100 but-
ton, then press the Number but-
tons for the last two digits. For
example, to select channel 125,
press +100, 2, 5. Precede single-
digit channel numbers with a
zero (for example, 01 ... 09).
• The TV/VCR cannot control or
change the channels of a Cable
Box or Satellite Receiver.
Helpful Hints
2 Press PLAY/▲ or STOP/▼ to select AUTO CH
PROGRAMMING. Then, press F.FWD/B.
The TV/VCR scans and memorizes available channels.
When scanning is complete, the TV/VCR will go to
the lowest available channel.
Press CH o/p to select memorized channels. Use
the Number buttons to select non-memorized chan-
nels.
TIME SEARCH MUTE RECORD
SPEED RESET
0
8 9 7
5 6 4
2 3 1
PAUSE/STILL
+100
STOP
F.FWD
PLAY
REW
VOL.
DISPLAY
MENU
POWER SLEEP/WAKE UP
CH.
ALT.CH
1
– M E N U –
TIMER PROGRAMMING
PICTURE CONTROL
SETTING CLOCK
B CHANNEL SET UP
USER’S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
– CHANNEL SET UP –
ADD / DELETE CH (CATV)
B AUTO CH PROGRAMMING
1-2
The TV/VCR can memorize available channels for your area.
You can reset channels at the TV/VCR by following the steps
below.
If you are using a Cable Box or Satellite Receiver, you do not
need to set channels at the TV/VCR. Set the TV/VCR to the
output channel of the Cable Box or Satellite Receiver (chan-
nel 03 or 04).Then select the channel to be viewed on the
Cable Box or Satellite Receiver.
1 Press MENU. Press PLAY/▲ or STOP/▼ to
select CHANNEL SET UP. Press F.FWD/B.