Micron Technology USB Camera - Manual (Page 33)

Sensor Control: Image Correction
29 SMX-M8xx Series USB2.0 Camera User Guide
Use one of the radio buttons on the Predefined control to set one of the predefined
viewport sizes. The Viewport rectangle position may also be changed by dragging the
video image in the View window.
Image Correction
The Image Correction controls are designed for setting up the camera's Brightness,
Contrast and Gamma (
see Figure 3-2 The SMX-M8X Camera Application main window
outlook ).
This correction is done programmatically by the camera firmware using the conversion
(look-up) table of the values. The correction does not affect any electrical settings of the
camera. To use the Image Correction controls, check the Enable command -
Brightness, Contrast and Gamma become editable.
The default values of Brightness, Contrast and Gamma are set to 0; 0; 1, 00,
respectively.
You can restore the default values of the Image Correction controls on any step of
changes: simply click the Default button on the Image Correction tab.
The Best button, if applied, activates application to transform the look-up table of 8
and10 bit to increase the dynamic range.
Note: The SMX-M8xx Camera Software does not display changes of the Image Correction look -up table when the
Best button is applied
With every change of any image correction controls, you can view a graphical
interpretation of the dependence of the image's changes on the changes of the Image
Correction controls (
see Figure 3-2 The SMX-M8X Camera Application main window outlook ).
Note: The default values of Image Corrections are the most suitable and recommended for performing White Bal-
ance (Hard)
Color Balance
The Color Balance controls are designed to adjust the ratio of the main induced color
components (Red, Green and Blue) on the image that is displayed by the camera
software.
This correction is done on the software level and does not affect any electrical settings
of the camera (
see Figure 4-2 The SMX-M8X Camera Application Color Balance Controls ).