Guidelines for using twain driver, Overview, Installation – Micron Technology USB Camera User Manual
Page 53: How it works, Location, Chapter 10 guideline, See chapter “guidelines for using twain driver, Setup, See chapter “installation, Twain d
Guidelines for Using TWAIN Driver
49
Chapter 10
G
UIDELINES
FOR
U
SING
TWAIN D
RIVER
Overview
To get a picture from the SMX-M8xx Camera you can use the Scanners and Cameras
operation - the standard Window's Administrative Tool (Start> Control
Panel>Scanners and Cameras).
You can also use almost any of the image editing programs to get the image from the
SMX-M8xx Camera using Scanners and Cameras. This action is available in almost all
image editing programs.
The information in this section of the document is based on the image editor that is
always available in Windows XP - Microsoft Paint.
To use the SMX-M8xx Camera for getting images, you should first install the required
software - TWAIN Driver.
Installation and use of TWAIN Driver requires that the needed hardware for the camera
use is already installed (
Note:
Installation and further use of TWAIN Driver is supported only by Windows XP operating system
Installation
If the TWAIN Driver was installed during the SMX-M8x USB2.0 Camera Software
Package installation (
see chapter “Automatic Camera Installation”
), it is ready to be used.
If the TWAIN Driver was not installed during the SMX-M8x USB2.0 Camera Software
Package installation (
see chapter “Automatic Camera Installation”
), browse to the Sumix
folder where the SMX-M8xx USB2.0 Camera was installed and open the \SMX-M8X
USB2.0 Camera\Drivers\TWAIN folder. In order to install the TWAIN Driver run the
SMXM8WIA application file. Wait a few minutes for the driver installation to complete.
TWAIN Driver is installed and ready to be used.
How It Works
Location
Open the Control Panel window (Start>Control Panel) and open Scanners and
Cameras (
see Figure 10-1 Scanners and Cameras in the Control Panel window