Memorex MPD8300 - Manual (Page 7)

6
RECHARGEABLE BATTERIES
1. Insert the negative side of a rechargeable NI-CAD battery into the
sleeve as shown. The sleeve must be inserted onto the negative side
of the battery, otherwise it will not work.
2. Open the battery compartment door on the bottom of the unit by
sliding it out and then lifting it. To prevent the possibility of losing
the cover, it cannot be removed.
3. Insert two (2) “AA” rechargeable NI-CAD
batteries (not included) as shown. Make sure
the rechargeable battery with the sleeve is
inserted in the position as shown at the right,
otherwise the batteries will not charge.
4. Close the battery compartment.
5. Plug the small end into the DC 4.5V jack on
the rear of the unit and connect the other end
into the AC outlet; charging will begin.
6. When charging is completed, disconnect the AC adapter plug from the
unit and the AC outlet.
NOTES :
• The batteries are fully charged after approximately 15 hours after the
AC adapter is connected. More time may be required for charging in
cold temperatures, but never more than 24 hours.
• After 24 hours, please unplug the AC adapter.
• With care, rechargeable NI-CAD batteries can be recharged over 500
times.
• If the operating time decreased drastically, even when the NI-CAD
batteries are properly recharged, purchase new rechargeable NI-CAD
batteries.
• Only NI-CAD batteries can be recharged in this unit. Do not attempt to
charge any other type of rechargeable or standard battery.
POWER SOURCES (CONTINUED)
–
+
–
+ –
+
–
+
+
Sleeve
Charge
Spring
MPD8300.OM 8/12/03 9:32 AM Page 6