Miele CVA 2660 - Manual (Page 53)

Drip tray
There is a sensor in the drip tray which causes a message to
appear in the display when the drip tray is full and needs to
be emptied. Remove the tray and empty and clean it when
this message appears.
However, to avoid a build-up of odours, the drip tray should
be cleaned every day.
After running the last rinse, you should leave the drip tray
in position for a while before cleaning it so that you catch
any remaining water from the pipework.
^ Open the front of the machine.
^ Remove the drip tray from the machine with care.
There is a grid in the drip tray. This grid helps prevent the
water from spilling out of the drip tray when it is being
carried.
^ Clean the drip tray and the grid with hot water and a little
washing-up liquid or in the dishwasher, and dry with a
cloth.
Make sure that the metal contact discs at the top of the
drip tray are cleaned and dried properly. These contacts
let the machine know when the drip tray is full or if it is not
in the machine. They will not convey these messages if
they are dirty or damp.
^ Push the drip tray with the grid along the right-hand edge
back into the machine.
^ Close the front of the machine.
53
Cleaning and care