Miele CVA 2660 - Manual (Page 74)

. . . there is water in the waste container
This is not a fault. The water is left over from the brewing and
cleaning process.
. . . there is residual "coffee water" in the waste container
The capsule plate is not correctly pushed in.
^ Remove the capsule plate and replace it.
. . . the descaling process was started by mistake?
The descaling programme cannot be cancelled once you
have pressed the right hand dial. The programme has to be
completed through to the end. This is a safety measure to
ensure that the machine is fully descaled, and is important
for protecting the machine and to ensure it functions
correctly.
. . . the heating-up time is getting longer, the amount of
water coming through is incorrect and the machine is not
performing properly
The machine needs descaling.
. . . the error message F 10 appears
Water has not been taken in.
^ Perhaps the system was not filled with water before the first
drink was made. Fill the system with water as described in
"Making coffee: Filling the system with water".
^ Or the water container has not been correctly positioned
inside the machine. Remove the water container and push
it back into position again, making sure it engages
correctly.
^ This error message also appears if the water container was
not correctly filled for descaling. Fill the container to the
mark, and start the descaling process again.
^ If this fault message keeps on appearing, please call the
Miele Service department, quoting the fault code.
Problem solving guide
74