Miele CVA 2660 - Manual (Page 66)

Put the coloured descaling funnel in its place.
The descaling procedure will not start for another 5
minutes or so. This time is needed to allow the descaling
tablets to dissolve fully in the water. It will take longer than
this to start if the appliance is too warm.
During descaling a little water and descaling agent will run
out of the coffee and steam spouts. This is followed by an
activation period, before more descaling agent is drained out,
and so on. A message will appear in the right-hand display
letting you know approximately how long this procedure will
take.
^ When a message asking you to
fill the water container
with fresh water appears in the right-hand display, you
should remove the container and rinse it out thoroughly with
clean water. Make sure all traces of descaling agent are
removed, and then fill it with clean drinking water.
Empty the
waste container at the same time.
Water will flow out of both spouts during the rinsing process.
The
drip tray will need to be emptied several times during
this process.
When descaling is finished, Programme finished, open the
door will appear in the display. Open the machine front and
follow the instructions given in the right hand display.
The machine will run another brief rinsing programme, and is
then ready for use again.
Descaling the machine
66