Multiquip SCRUCTURAL CONCRETE PUMP ST-45HRM - Manual (Page 112)

PAGE 112 — MAYCO ST-45HRM PUMP — OPERATION & PARTS MANUAL — REV. #4 (07/16/04)
GREASE POINTS
ST-45 PUMP — LUBRICATION PANEL
NOTE:
Grease daily, two or three hots
of #2 multipurpose automotive
grease. Over greasing any
bearing will not damage the
machine. ALWAYS grease
before and after pump
operation.
POSITION LOCATION LENGTH OF LINES
A ................................................. PIVOT BRACKET GREASE POINT ................................. 41 in. (1.5 m)
B ................................................. AXLE CRANK GREASE POINT ....................................... 34 in. (1.1 m)
C ................................................. SWING AXLE BUSHING GREASE POINT ...................... 26 in. (.85 m)