Multiquip SCRUCTURAL CONCRETE PUMP ST-45HRM - Manual (Page 30)

PAGE 30 — MAYCO ST-45HRM PUMP — OPERATION & PARTS MANUAL — REV. #4 (07/16/04)
ST-45 PUMP — INSPECTION
ENGINE OIL CHECK
7. Remove the engine oil dipstick from its holder (Figure 12).
Figure 12. Engine Oil Dipstick
10. Verify that oil level (Figure 13) is maintained between
the two notches on the dipstick.
11. If the pump's engine oil is low, fill engine crankcase
with lubricating oil through filler hole, but DO NOT overfill.
8. Make sure pump/engine is placed on level ground.
9. Pull the engine oil dipstick (Figure 13) from its holder.
Figure 13. Engine Oil Dipstick
Hydraulic Oil
13. Determine if the hydraulic oil level is low by observing the
level of the oil in the Hydraulic Oil Sight Glass (Figure 14).
12 The oil listed in Table 47 is recommended to ensure
better engine performance. Use class CD or higher grade
motor oil.
Figure 14. Hydraulic Oil Sight Glass