Maxxsonics High Definition Video Server MAXX-2400HD - Manual (Page 121)

MAXX-2400HD Owner’s Manual Page 121
System Board Ports
Standard computer I/O ports on the server include video monitor, keyboard, mouse, and
Gigabit Ethernet. Pinouts are provided to assist in wiring or trouble-shooting.
Keyboard and Mouse
Keyboard and mouse ports are provided on the rear panel. Both ports are provided with a
resetable fuse protecting the +5V supply to the peripheral.
SVGA Ports
An SVGA computer monitor may be connected to the 15-pin video port. The server is pre-
configured to an SVGA screen resolution of 1024 x 768 and 64,000 colors. The refresh rate will
auto-negotiate with the attached monitor to achieve the best available value. This resolution is best
viewed on 17-inch or larger monitors. Use only VESA compliant monitors. 360 Systems does not
provide a monitor with the server.
SVGA Connector Pinout
Pin Signal Pin Signal
1 RED 9 +5V
2 GREEN 10 GND
3 BLUE 11 R ESERVED *
4 R ESERVED * 12 SDA
5 GND 13 HSYNC
6 RED RTN 14 VSYNC
7 GREEN RTN 15 SCL
8 BLUE RTN S HELL F RAME GROUND
* Pulled high to +5V.
Unused Ports
USB ports and an RS-232 serial port are present on the server. These are not active and no
connection should be made to them. (USB ports may be used for software/firmware update devices
only. There are no provisions for USB keyboard, mouse or mass storage devices, and their use may
cause the server to operate improperly.)