Minolta DI2510 - Manual (Page 53)

3 3.5 Turning the Copier On and Off
3-12 Di2010/Di2510/Di3010/Di3510
B
e
fo
re
Ma
ki
ng
C
o
pi
es
Chap
ter
3
Auto Panel Reset
When a specified period has passed, these will reset to the default settings.
<Conditions for auto panel resetting>
● 1 minute, or a specified period after the copier is last used (factory default set-
tings are 1 minute).
● The magnetic card is removed from the data controller or the key counter is re-
moved.
✎
Note
The settings specifying whether or not and the time until the auto panel reset
operation is performed can be changed. For details, refer to “Changing Default
Settings” of “Utility Mode Operations” in the Advanced Operations volume of the
User Manual.
Energy Save Mode
In order to conserve energy, the copier will automatically enter a stand-by mode
(Energy Save mode) if no operation is performed for a specified length of time.
When the copier enters Energy Save mode, the indicator on the [Start] key remains
lit in green, but the touch panel goes off.
At this time, the copier reduces the heat of the fusing section, and goes into Energy
Save Mode.
<Conditions for entering Energy Save mode>
● 15 minute, or a specified period after the copier is last used (factory default set-
tings are 15 minute).
✎
Note
To recover from Energy Save mode, press any key in the control panel or touch
the touch panel.
The copier will not enter Energy Save Mode while printing is paused.
The settings specifying whether or not and the time until the copier enters En-
ergy Save mode can be changed. For details, refer to “Changing Default Set-
tings” of “Utility Mode Operations” in the Advanced Operations volume of the
User Manual.