Sleep mode, 6 adjusting the angle of the control panel, Sleep mode -13 – Minolta DI2510 User Manual
Page 54: Adjusting the angle of the control panel -13
3.6 Adjusting the Angle of the Control Panel
3
Di2010/Di2510/Di3010/Di3510
3-13
B
e
fo
re
Ma
ki
ng
C
o
pi
es
Chap
ter
3
Sleep Mode
In order to conserve energy, the copier’s heater goes off and the copier automati-
cally enters Sleep mode if no operation is performed for a specified length of time.
<Conditions for entering Sleep mode>
●
No copier operation is performed for 1 minute.
✎
Note
To recover from Sleep mode, press any key in the control panel or touch the
touch panel.
The settings specifying whether or not and the time until the copier enters Sleep
mode can be changed. For details, refer to “Changing Default Settings” of “Util-
ity Mode Operations” in the Advanced Operations volume of the User Manual.
3.6
Adjusting the Angle of the Control Panel
The control panel can be adjusted to any of three angles.
Adjust the control panel to the angle that allows for easy operation.
➜
Pull the control panel release lever, and then adjust the angle of the control
panel.
➀ Upper position
(base position)
➁ Middle position
➂ Lower position