Miller Electric DVI-2 R - Manual (Page 27)

.
A complete Parts List is available at www.MillerWelds.com
OM-232 386 Page 23
SECTION 5 − OPERATION
5-1. Controls
1 Voltage Control
Set Voltage control according to the
parameter chart for good starting point.
Turn control clockwise to increase voltage.
2 Wire Speed Control
Set Wire Speed control according to the
parameter chart. Increase or decrease wire
speed to obtain desired bead profile and
travel speed.
3 Over Temp Light
If unit overheats, light turns on and output
stops. Allow unit to cool before resuming
operation.
Ref. 226 649-C
3
1
2