Introduction, Features, Main features – Midland Radio SP-300 User Manual

Page 8: Wideband, Scan mode, Scan channel delete, Maxon sp-300 series hand held, Introduction features

Advertising
background image

MAXON

SP-300 Series HAND HELD

Page -5-

May 2001

SP-300

The SP-300 Series of portable radios from Maxon, utilizes
the latest technology in its design and manufacturing. Both
the VHF and UHF models are PLL (Phase Lock Loop Syn-
thesizer) / microprocessor controlled, and offer 1 or 5 watts
of power with 4 & 16 channel capability. Multiple functions
including Scan, CTCSS / DCS signaling and 12.5 & 25 kHz
channel spacing are standard in these fully programmable
wide bandwidth handheld units.

Main Features

• Wideband

• Scan Mode

• Busy Channel Lockout/Marked Idle Enable

• Standard/Non-Standard CTCSS/DCS Signaling

• Transmit Time-Out Timer/Tx Inhibit

• Beep Tone Enable/Disable

• Low Battery Indication

• Memory Protect

• External Option Detect

• 5/1 Watts Programmable RF Power

• Battery Save Circuitry

• Locking Accessory Connector

Wideband

This software is made to work and control the wide band
receiver/transmitter boards.

Scan Mode

During programming of the radio, any channel can be
selected as a scanned channel. When a channel is selected as
a scanned channel, it becomes part of the scan list. The scan
list will be activated by switching to the channel that was
selected as the scan channel during programming of the sys-
tem parameters.

The channel that was selected as the scan channel can still be
used as a receive only channel when in scan mode or receive
and transmit channel if the channel has been programmed for
“Priority Scan TX”.

Scan Channel Delete

When the unit is in scan mode the monitor button can be
pushed to delete a channel from the scan list. If the monitor
button is pushed while scanning has stopped to monitor an
active channel, that channel will be deleted from the scan
list. The channel will remain inactive in the scan list until
the scan mode is re-initiated by switching off the scan list
channel and switching back to the scan list channel. Any
number of channels can be deleted from the scan list in this
way. The scan list is always initiated with all the scan list
channels active.

INTRODUCTION

FEATURES

Advertising