Installing the remote control batteries – MITSUBISHI ELECTRIC WD-57732 User Manual

Page 35

Advertising
background image

Chapter 3. TV Setup

35

Installing the Remote Control
Batteries

1. Remove the remote control’s back cover by gently

pressing in the tab and lifting off the cover.

2. Load the batteries, making sure the polarities (+) and

(-) are correct. For best results, insert the negative (-)
end first.

3. Snap the cover back in place.

2

1

The remote control requires two AA alkaline batteries.

TV Tips

Turning the TV On or Off

To turn the TV on or off, point the remote control at the
front of the TV and press the

POWER button. Alternatively,

press the

POWER button on the front panel of the TV.

If You Turn Off the TV by Mistake

1. Press

POWER again within about 30 seconds, while

the lamp is still hot, to have the TV come back on
immediately.

2. If the

LAMP indicator starts blinking (about 30

seconds after you shut off power),

wait about one

minute for the LAMP indicator to stop blinking and
press POWER to turn the TV on again.

Controlling Sound Volume

Press

VOL / to adjust the sound level.

Changing Channels

To change channels:
• Enter the channel number using the number keys on

the remote control and press

ENTER. For a two-part

digital channel, such as 3-1, press

3 —

CANCEL 1 to enter

a dash (separator).

• Press

CH / to change channels one channel at

a time.

• Press and hold

CH / to move quickly through

channels.

• Press

QV (QuickView) to switch back to the previ-

ously tuned channel.

• Use the FAV (Favorites) feature to set up lists of

favorite channels and tune to them with the

FAV key.

See “Channel Menu” in chapter 5.

NOTE: Memorize channels to make finding channels

easier.

Care of the Remote Control

• Use only alkaline batteries.
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same time

unless instructed to do so.

• Do not allow unit to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only a soft,

lightly moistened cloth.

• Do not mix old and new batteries.
• Do not heat, take apart, or throw batteries into fire.

Advertising