M-AUDIO Digital Recording Interface Delta 44 - Manual (Page 14)

14
Analog 1/2 Delta-44
Analog 3/4 Delta-44
WINDOWS MULTIMEDIA SETTINGS: Windows may be set up to use the
Delta 44 as its default audio device, allowing system sounds to be sent out the
Delta 44. This also enables you to use the Delta 44 with the sound applets included
with Windows. To set this up, go to Control Panel | Multimedia. In the Audio
Properties page, set the Playback and Recording devices to the Delta 44 input and
output devices of your choice.
Delta 44 Control Panel Software
ON THE PC: Once the Delta 44 is properly installed, an "M Audio Delta H/W" icon
will be displayed in your Windows Control Panel. By double-clicking on that icon,
you will launch the Delta Control Panel software. You may also launch the Delta
Control Panel software from the desktop if you have previously created a shortcut
there (see "Verifying Delta Control Panel Software Installation" section for
instructions on how to do this). Once the Delta Control Panel software has been
opened, you will see the main panel and its several tabs. To display a desired page,
click on its tab. Below are functional descriptions of each page.
ON THE MAC: The Delta Control Panel must be placed on the hard drive by
dragging the application from the Drivers CD. Once this is done, an alias may be
created by highlighting the Delta Control Panel on the hard drive and pressing the
Apple key+M. Then, this shortcut may be dragged to the desktop. Double clicking
either will launch the control panel. Once the Delta Control Panel software has been
opened, you will see the main panel and its several tabs. To display a desired page,
click on its tab. Below are functional descriptions of each page. Though most of the
desciptions are Windows based, the functions are identical unless otherwise
indicated. Within each section you will find the necessary name changes for using
the Delta Control Panel “ON THE MAC.”
NOTE: When using a music software program that is ASIO
capable, launch the Delta Control Panel software from within that
program. There will be a button in the ASIO or Audio setup page
that will allow you to do so. Some of the control panel functions
will be controlled from within that program, such as master clock
setting and sample rate, so it is desireable to launch the music
program first, and then the Delta Control Panel from the the
program’s “launch” or “control panel” button. Without the music
program open however, it is okay to open the Delta panel from
your desktop or other location.