M-AUDIO Digital Recording Interface Delta 44 - Manual (Page 28)

28
playback levels of your guitar and mic. Adjust the faders and mute controls so that
you may hear the guitar and mic at the appropriate levels and mix. These are the levels
at which you may monitor the pre-recorded tracks while you overdub (record other
tracks while listening to the first) additional parts.
Let’s assume that you like this take, and wish to overdub an additional guitar and a
harmony vocal. We can still use hardware inputs 1 & 2 of the Delta. We’re set up
to do so and there’s no reason to change these inputs. Let’s set ourselves up to
overdub these next two tracks. We will record the next two tracks of material to
tracks 3 & 4 of the software:
18. Back in your music program, set the ‘source’ or ‘input port’ to “Left PCM In 1/2
Delta-44” on track three, and “Right PCM In 1/2 Delta-44” on track four. Arm
the tracks for recording. Track three is now set up to record the guitar, and track
four the microphone. Usually at this point you would want to return to the Delta
Control Panel monitor mixer to set up levels. However, because you will be
recording the same instruments that you did on the first two tracks, you probably
won’t need to adjust input or monitoring levels.
19. Press record on your software’s transport bar. Record a take of your new guitar
and vocal tracks. Because you have set up the first two tracks to play back
through the monitor mixer, you should hear those original tracks along with the
ones that you are now recording.
20. When you are done playing, stop the recording software and rewind the take.
Before playing back what you’ve recorded, you will need to assign the newly
recorded tracks to output devices on the Delta 44. In your software, set the
output ports of tracks three and four to “WavOut 3/4 Delta-44.” Pan track three
all of the way to the left (hard left), and pan track four all of the way to the right
(hard right). Now track three (guitar) will be sent to the Delta software output 3,
and track four (mic) to Delta software output 4.
21. Press play on your software’s transport bar. Understand now that the four
recorded tracks from the software are being sent to WavOut 1, WavOut 2,
WavOut 3, and WavOut 4 simultaneously. Therefore they are all being input to
the monitor mixer and their playback levels can be controlled at the
corresponding channels of the monitor mixer. Open the Monitor Mixer page of
the Delta Control Panel and adjust the levels of the four channels according to
your taste. You may also experiment with the Mute and Solo controls while
listening to the playback. Note also that the mixer continues to monitor the
guitar and mic at analog inputs 1 & 2!
At this point, you should be able to see how this multi-tracking session is
developing. As we add more tracks within our music software, we set them to the
next pair of Delta software outputs, and bring up the faders of those software inputs
in the monitor mixer. We continually monitor from the Delta hardware outs 1 & 2,
via the ‘Mon.Mixer’ setting as the monitor ‘source’ in the Patchbay/Router page, and
adjusting our mix of the software outputs (and the way we monitor our guitar and
vocal at the inputs) via the Monitor Mixer settings.