Maytag WINSLOW PI40 - Manual (Page 32)

3
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
6. Installing access panel: Taking the access panel (E in Figure 61) and
4 of the sheet metal screws provided, screw the access panel E onto
the right side panel C as shown in Figure 61).
7. Final step: Using the four oblong washers and 4 sheet metal screws,
insert two on each lower side of your ZC box shown in Figure 62. You
are now ready to install your pellet insert. Follow all vent clearances
stated in the installation and operation manual.
5. Now remove the 3 screws located across the top of the pellet hopper.
(See Figure 59). At this time set the assembled ZC box near the back
of the insert and take the power cord located in the lower rear of the
insert and pull it through the rubber grommet located at the bottom
of the back panel A. Then on the right panel C, pull the wiring harness
through the rubber grommet located towards the bottom Figure 60.
Slide the ZC box snug up against the back of the insert and reinstall
the 3 screws previously removed through the ZC box and into the
insert (three holes shown in Figure 59).
Figure 59
Figure 60
Figure 62
Figure 61
E
C