Motorola D1010 - Manual (Page 29)

Help 29
3. Press
m
, PLAY is displayed.
4. Press
m
, the handset will start the new message playback. Once
all messages are played, the handset will return to standby.
NOTE
During message playback, press
>
anytime to return to standby.
Memory full
The memory is full if there is less than 15 seconds of recording time left
or if the maximum total of 59 messages has been reached.
When the memory becomes full:
• The LED will flash quickly.
•
flashes quickly on the handset display.
• The machine will automatically switch to Answer Only mode.
If the memory becomes full while a caller is leaving a message, they will
hear a beep and the call is ended.
10. Help
Charging
The icon is not scrolling when the handset is placed on the base
• Bad battery contact – move the handset slightly
• Dirty contact – Clean the battery contact with a cloth moistened with
alcohol
• Battery is full – no need to charge
Calls
No dialling tone
• No power – check the connections. Reset the phone: unplug and plug
back in the mains
• Batteries are empty – charge the batteries for at least 24 hours
• You are too far from the base – move closer to the base
• Wrong line cable – use the line cable provided
• Line adaptor (when needed) is not connected to the line cord –
connect the line adaptor (when needed) to the line cord
Poor audio quality
The base is too close to electrical appliances, reinforced concrete walls
or metal doorframes – move the base at least one metre away from any
electrical appliances
The
icon is blinking
• Handset is not registered to the base – register the handset to the
base
• You are too far from the base – move closer to the base
No ring tone
• The ring tone is deactivated.
• Increase the volume.
Caller Line Identification (CLI) service does not work
Check your subscription with your network operator
Phonebook
A phonebook entry cannot be stored
The phonebook is full. Delete an entry to free memory