Magnadyne MARKSMAN X11 - Manual (Page 11)

When the Security System is triggered, it will alert the user with flashing icons on the LCD Display
and audible melody sound. To stop the melody sound, press any button on the LCD transmitter.
When the Security System is triggered, the LCD screen will alert the user through melody sound
and flashing icons. By pressing the “SET” button 3 times within 3 seconds it will clear the flashing
icons and stop the melody sound.
The X11 security system has a built-in Noise Abatement Circuit that prevents annoying, repetitive
false alarms by filtering out environmental conditions. If the security system is triggered more
than five times by the same sensor , the circuit will interpret this as a false alarm and ignores, or
bypasses that switch or sensor.
The Noise Abatement Circuit monitors doors, hood and trunk switches differently. If the security
system is triggered by one of these switches for three cycles, the switch will be bypassed until the
trigger ceases.
Warning: The anti-car jacking feature default setting is “OFF”. Have your installation facility enable
this feature if you feel it is needed.
1. Press and hold the transmitter and buttons at the same time for 2 seconds while the
vehicle’s ignition is “ON” and all doors are closed. The parking lights will turn on for 1.5
seconds to indicate the anti-car jacking protection is armed.
2. Once the system is armed, if you are forced from your vehicle, the system will trigger when the
door is opened and closed while the ignition is “ON”.
1. Close all entrances first then turn the ignition switch to the “ON” position, the anti-car jacking
system will arm.
2. Once the system is armed, if you are forced from your vehicle, the system will trigger when the
door is opened and closed while the ignition is “ON”.
Trigger the System (continued)
Anti-Car Jacking
11
LCD Transmitter Melody Sound
LCD Transmitter Clear the Flash Icon and Melody Sound
Noise Abatement
Manual Anti-Car Jacking
Passive Anti-Car Jacking