Magnadyne MARKSMAN X11 - Manual (Page 20)

20
While triggering the alarm, the LCD screen will alert the user through melody sound and flashing
trigger icon. Press any button on the transmitter to stop melody sound only.
Use this mode to disable the transmission function of the remote control temporarily to prevent
any inadvertent pressing of buttons.
1. Press the “SET” button first, within 3 seconds press and hold the button for 2 seconds to
activate or cancel the button lock function. The icon will be displayed on the LCD screen
to show button lock mode.
This mode is useful when you are in a noisy place and it is difficult to hear the beep from the
remote. The LCD transmitter will vibrate if your security system has been activated.
Press the “SET” button first, within 3 seconds press the ( ) button for 2 seconds to select
the mode of vibrate/melody. The icon will be displayed on the LCD screen to show mode.
Press the “SET” button first, then within 3 seconds press and hold the button for 2 seconds.
The LCD screen will show the icon and timer (0:10). Press the button again to choose the
desired time.
Note: 1. The countdown periods are fixed at 10 minutes, 20 minutes, 30 minutes, 1 hour, 1.5
hours and 2 hours maximum.
Note: 2. Press the SET button for a real time indication of the remaining time left.
Note: 3. When the display is showing 0:00, the timer is off
1. If the transmitter is within range, the icon will display on the LCD screen.
2. If you are out of range, the icon will disappear from LCD Screen and transmitter will beep 5
times.
Programming of the LCD Transmitter
Stop the Trigger Melody
Button Lock
Vibration/Melody Mode
Set-Up Fixed Count Down Timer
Out of Range Indication