MITSUBISHI ELECTRIC Mitsubishi LCD Projector FL7000U - Manual (Page 38)

EN-38
This projector includes a terminal cover with Anti-Theft
Alarm device. Once the terminal cover is installed, its
Anti-Theft Alarm device will detect vibration caused by
the projector being moved and emit an alarm.
• Mitsubishi assumes no responsibility or liability for
theft or other damages.
Procedure for setting the anti-theft alarm
device
Inserting the batteries into the theft warning device
1. Open the battery cover of the theft warning device.
2. Check the (+) and (-) ends of the battery, and insert
it from the (-) end fi rst.
Battery cover
Battery Switch
ON
• Inserting the battery from the (+) end makes
it diffi cult to fi t the (-) end into the coil spring.
Forcing in the battery in such a position may
shred the outside label, causing a short circuit
and overheating.
• See page 6 for information on how to handle
batteries.
3. Close the battery cover.
Safety pin hole
Safety pin Screws
4. Insert the included safety pin into the safety pin
hole.
• If the safety pin is not inserted, the vibrations
and shocks of normal use may cause the alarm
to sound.
5. Turn the power switch ON.
Installing the terminal cover
1. Insert the four tabs on the terminal cover into the
holes on the projector’s side.
2. Slide the terminal cover toward the back of the
projector.
Tabs
3. Tighten the three screws that keep the terminal
cover in place.
4. Install the projector in a specifi ed location.
Terminal cover (with anti-theft alarm device)
5. Press the battery level check button until you hear
a buzzer sound.
6. Remove the safety pin.
The anti-theft alarm device is now in standby.
• This package includes a sticker which shows
that the anti-theft alarm device is active. Visible
placement of this sticker is recommended.
• To temporarily halt the anti-theft alarm device,
insert the safety pin.
• Vibrations will not cause the alarm to sound for
several seconds after the power switch is turned
ON.
• Vibrations will not cause the alarm to sound for
several seconds after the safety pin is removed.
• Vibrations and shocks from earthquakes may
cause the alarm to sound. In such situations,
insert the safety pin to halt the alarm.
• Batteries may come loose during transportation.
Please remove them beforehand.
Procedure for changing batteries
How to check battery level
Use a pointed object to push the battery level check
button.
Battery level
check button
• A buzzer will sound while the button is being
pushed. If there is no buzzer sound, then batteries
need to be changed.
• Sounding the buzzer for a long time will consume
battery power.
Changing the batteries
1. Insert the safety pin into the safety pin hole.
2. Loosen the three screws that keep the terminal
cover in place.
3. Slide the terminal cover toward the front of the
projector.
4. Pull the terminal cover toward you and remove it.
• Attention must be paid when removing the
terminal cover as there could be foreign objects
inside.
• Removal of dust found inside the terminal cover
is recommended when changing batteries.
5. Open the battery cover and remove the old
batteries.
6. Check the (+) and (-) ends of the new battery, and
insert it from the (-) end fi rst.
• Use alkaline AA batteries.
• Standard battery life is approx. six months (when
using alkaline dry cell batteries). Please check
the battery level and change batteries regularly.
7. Close the battery cover.