MITSUBISHI ELECTRIC Mitsubishi LCD Projector FL7000U - Manual (Page 9)

EN-9
Using the remote control
30° 30° 30° 30°
20°
10°
20°
10°
20° 20°
Operational range of the remote control
• Keep the remote control photo-sensor out of direct
sunlight or fl uorescent lamp light.
• Keep the remote control photo-sensor at least 2 m (6
feet) away from fl uorescent lamps. Otherwise, the
remote control may malfunction.
• If there is an inverter-operated fl uorescent lamp
near the remote control, the remote control opera-
tion may become unstable.
• When you use the remote control too close to the
remote control sensor, the remote control may not
work correctly.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Front of projector Rear of projector
Operate the remote control
within a distance of 10 m
(30 feet) from the projector,
pointing the light beam at
the remote control photo-
sensor (front or rear) of the
projector.
When operating the remote control, keep the distance
from the remote control to the projector via the
screen within about 5 m (15 feet). The operable range
of the remote control, however, depends on the
characteristics of the screen.
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.
• For connection, use the pin-pin cable of ø3.5 stereo
type, which is commercially available. However,
some cable may not work correctly.
• When REMOTE OUT terminal on this projector is
connected to the REMOTE IN terminal on the other
projector, the two projectors can be controlled
together by using the remote control. (Up to two
projectors can be controlled.)
• When the remote control is connected with remote
control cable, it does not work as a wireless remote
control.
• When using the wired remote control, the laser
beam may be darker. It is normal.
REMOTE IN
REMOTE OUT REMOTE IN