Minolta CF910 - Manual (Page 43)

3-11
3. Basic Functions
M
a
ki
ng
C
o
pi
es
Chapter 3
Manual Bypass Copying
• Use the Manual Bypass to make copies on paper not loaded in any tray, or to copy onto OHP
transparencies or any other special paper.
• The setting of copy paper sizes is needed for manual bypass copying.
• Manual Bypass cannot be used for a reserved job.
◆Types of Paper
• Plain paper
Thin Paper (20 lbs.), CF Paper (20 lbs. to 24 lbs.)
• Thick paper
Heavy Stock 1 (24 lbs. to 28 lbs.), Heavy Stock 2 (50 lbs. to 60 lbs. cover)
• OHP Transparencies (recommended brand)
◆Paper Size
• 11”
×
17”L to LetterC and 12”
×
18”
• Postcard
• Max. Size: 11-3/4”
×17
”
• Minimum Size: 5-3/4”
×
7-1/4”
◆Capacity of the Manual Bypass Tray
• Plain paper, Heavy Stock 1 ... Up to 50 sheets
• Plain paper (once-copied paper) ... Up to 20 sheets
• Heavy Stock 2, OHP transparencies ... Up to 20 sheets.
Place the original on the Original Glass.
Swing down the Manual Bypass Tray.
Insert a neat stack of copy paper into the
Manual Bypass Tray until it stops and slide
the Paper Guide Plates to the size of the copy
paper.
NOTES
• Load the OHP transparencies so that the front
side (on which the white tape is fitted) faces up
in the direction as shown.
• Use only the recommended OHP
transparencies.
• Only CF Paper can be used for 2-sided copies.
• When inserting paper with one side previously
printed, load the paper stack so that the blank
side faces down.
• Make sure that the top level of the original
stack does not exceed the ▼ marking.
Copy Paper that Can be Used for Manual Bypass
Using the Manual Bypass Tray
1
2
1144O012AA
3
1144O013AA
1144O014AA