Midland Radio RG2W or RG2B - Manual (Page 24)

Page 24
4 If you desire to change the name or the code, press one of the 2 function
keys associated to the name or the MMSI code “►”.
9.b.5 If it is desired to eliminate completely the directory, press the function
key “Del” and confirm by pressing subsequently the function key “Yes”.If
you desire to cancel the operation, press the function key “NO”.

It is possible to memorize max. 16 addresses. If the directory is filled up, on the display
will appear the indication “Full” and it will not be possible to add further addresses. In this
case it is necessary to cancel some.
9.6 “Posn” (Setting of position co-ordinates and adjustment
of UTC time)
1. Press the function key “DSC”.
2. Press the key “Menu”.
3. Press the key “Posn”.
4. To insert the coordinates, press the function key “Posn” and through the
alphanumeric keypad, set up the coordinates.
5. Confirm by pressing the E-button. If “non-existent” coordinates have
been inserted, REGATTA 2 will emit a double error beep rendering
necessary the re-insertion.
6. In order to set the time, press the function key corresponding to “UTC”,
and confirm through the E-button the executed operation. An eventual
error message will indicate the wrong entry of time data.

The insertion of time coordinates is required to carry out DSC calls. If REGATTA 2 is
connected to a compatible GPS receiver (GPS 200) the setting of these data is not
compulsory. Sending DSC without setting position and time works but message will lack
the position and time data.
9.7 “LCD” (display contrast)
The user can adjust the display contract to optimise visibility according to ambient
conditions.
1. Press the function key “DSC”.
2. Press the function key “Menu”.
3. Press the function key “LCD”.
4. Using the function keys corresponding to “▼” ; “▲” you can increase the contrast
of the display.
5. Confirm by using one of the following buttons: C , 16, function key DSC, or the
PTT.

This setting remains stored on the Eeprom, therefore REGATTA 2 will maintain the same
settings when the radio is turned on again.
9.8 “Beep” (Enable/disable keypad beep)
In order to activate or to inhibit the beep to the pressure of the keys operate as
follows:
1. Press the function key “DSC”.
2. Press the function key “Menu”.
3. Press the function key “More”.
4. Press the function key “ More”.
5. Pressing the function key “Beep” activates or disables the acoustic message to
the pressure of the keys.

This setting remains stored on the Eeprom, therefore REGATTA 2 will maintain the same
settings when the radio is turned on again.
Fig. W