Multiquip Whiteman Concrete Saw FS3SP - Manual (Page 27)

MQ-WHITEMAN FS3SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #0 (07/15/02) — PAGE 27
CAUTION:
D
DO NOT attempt to operate the saw until the
Safety, General Information and Inspection
sections have been read and understood.
Depending on engine manufacturer, operating
steps may vary. See engine manufactures
operating manual. The following start-up procedure makes
reference to a HONDA 20 HP Engine.
1. Ensure the diamond blade has been mounted correctly and
that it raised above the surface you about to saw.
2. Connect a hose (water source) to the water input port of the
saw (see page 50, item 2, Water System Assembly), and
test for adequate flood water [ 4 to 5 gallons per minute (15
to 19 LT/min)].
Figure 19. Speed Control Lever
.
Figure 21. Choke Knob
FS3SP CONCRETE SAW— INITIAL START-UP
5. Pull the Choke Knob (Figure 21) up into the " OPEN "
position
Figure 20 Console Engine ON/Off Switch
NOTE
The CLOSED position of the choke lever enriches
the fuel mixture for starting a COLD engine. The
OPEN position provides the correct fuel mixture
for normal operation after starting, and for
restarting a warm engine.
4. PULL the Console Engine ON/OFF switch (Figure 20) to
the "PULL-ON" position.
CAUTION:
The engine governor speed has been set at the factory. Changing
the governor speed could damage the blade and/or the saw.
6. Place the throttle lever (Figure 22) halfway between fast
and slow for starting. All sawing is done at full throttle. The
engine governor speed is factory set to ensure optimum
blade operating speeds.
Figure 22. Throttle Lever
3. Set the Speed Control Lever(Figure 19) to the start
position(neutral) and hold lever against the start microswitch.