Multiquip Whiteman Concrete Saw FS3SP - Manual (Page 9)

MQ-WHITEMAN FS3SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #0 (07/15/02) — PAGE 9
WARNING:
Failure to follow instructions in this manual may
lead to serious injury or even death! This
equipment is to be operated by trained and
qualified personnel only! This equipment is for
industrial use only.
The following safety guidelines should always be used when
operating the MQ Whiteman FS3SP Concrete Saws:
GENERAL SAFETY
■ DO NOT operate or service this equipment
before reading this entire manual.
■ This equipment should not be operated by persons under 18
years of age.
■ NEVER operate this equipment without proper
protective clothing, shatterproof glasses, steel-
toed boots and other protective devices required
by the job.
■ NEVER operate this equipment when not
feeling well due to fatigue, illness or taking
medicine.
■ NEVER operate this equipment under the
influence or drugs or alcohol.
■ NEVER use accessories or attachments, which are not
recommended by Multiquip for this equipment. Damage to
the equipment and/or injury to user may result.
■ The manufacturer does not assume responsibility for any
accident due to equipment modifications.
■ Whenever necessary, replace nameplate, operation and
safety decals when they become difficult to read.
■ ALWAYS check the machine for loosened threads or bolts
before starting.
FS3SP CONCRETE SAW — RULES FOR SAFE OPERATION
■ ALWAYS refuel in a well-ventilated area, away from sparks
and open flames.
■ ALWAYS use extreme caution when working with flammable
liquids. When refueling, stop the engine and allow it to cool.
DO NOT smoke around or near the machine. Fire or explosion
could result from fuel vapors, or if fuel is
spilled on a hot engine.
■ NEVER operate the saw in an explosive
atmosphere or near combustible materials.
An explosion or fire could result causing
severe
bodily harm or even death.
■ Topping-off to the
fuel filler port is dangerous, as it tends to
spill fuel.
■ NEVER use fuel as a cleaning agent.
■ NEVER touch the hot exhaust manifold, muffler or cylinder. Allow
these parts to cool before
servicing engine or saw.
■ The engine section of this saw requires an adequate free flow
of cooling air. NEVER operate the saw in any enclosed or
narrow area where free flow of the air is
restricted. If the air flow is restricted it
will cause serious damage to the saw
or engine and may cause injury to
people. Remember the saw's engine
gives off DEADLY carbon monoxide
gas.
■ High Temperatures – Allow the engine to cool before adding
fuel or performing service and maintenance functions. Contact
with
hot components can cause serious burns.