Multiquip Whiteman Concrete Saw FS3SP - Manual (Page 28)

PAGE 28 — MQ-WHITEMAN FS3SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #0 (07/15/02)
FS3SP CONCRETE SAW — INITIAL START-UP
Stopping the Engine
NEVER stop the engine while the blade is in the cut, except for
extreme emergencies. A sudden stoppage of the engine at high
speed while in a cut could damage the blade and/or saw, and
may cause injury to the user or other in the operating area.
1. Place the throttle lever (Figure 22) in the slow position, and
listen for the engine speed to decrease.
2. Push the console engine ON/OFF switch (Figure 20) to the
“OFF” position.
7. Push the Start Switch(Figure 23) to start the engine
Figure 23. Start Switch
8. If the engine has started, slowly return the choke lever
(Figure 23) to the CLOSED position. If the engine has not
started repeat steps 1 through 5.
9. Before the saw is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guard and/or covers.
10. All sawing is done at full throttle. Your engine governor has
been set at the factory to ensure an optimum speed setting.
WARNING
The blade is spinning whenever the engine is running.
Raise the blade high above the surface when maneuvering the
saw. Damage to the blade and/or saw may occur if the blade
strikes the pavement.
CAUTION:
z NEVER stop the engine in the cut while
working at high speeds, except for
extreme emergencies.
Maneuvering The Saw