Multitech PROXYSERVER MTPSR1-120 User Manual
Page 15
15
Chapter 2 - Installation
Table 2-1. (cont’d.)
Step
Procedure
5.
If a cable modem, DSL modem, or your Internet LAN is being used, no cable connection
will be made to the RS232/V.35 connector on the back of the ProxyServer.
If the RS232/V.35 connector on the ProxyServer is going to be connected to a WAN
device (i.e., connecting your secure (private) LAN to an ISP, connect one end of an
RS232 or V.35 interface cable to the RS232/V.35 connector on the back of the
ProxyServer. Connect the other end of this cable to the WAN device.
6.
Turn on power to the ProxyServer by placing the ON/OFF switch on the back panel to
the ON position. Wait for the Fail LED on the ProxyServer to go OFF before proceeding.
This may take a couple of minutes to go OFF.
At this time your ProxyServer is completely cabled. Proceed to
to load the Firewall
software.