Mazda 2009 RX-8 - Manual (Page 252)

Black plate (252,1)
(Releasing a locked channel)
1. Select a channel to be released by
pressing the tune button. Example:
Select the locked channel (i.e. 100). At
this time,
“SR1 LOCK 100” is
displayed.
(Registered ID code input preparation)
2. Hold the auto memory button, then
press channel preset button 6, hold
both buttons together for 1.5 seconds.
3.
“ENTER PIN” appears for 2 seconds
which indicates that it is in code input
mode.
4.
“SR1 - - - -” appears, which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example:
When the registered ID code is
“2323”,
input
“2323”. At this time “SR1 2323”
is displayed. Press the auto memory
button after the code is input.
NOTE
If
“Err” is displayed, go to the
“INITIALIZATION OF ID CODE” section to
reset the ID code to [0000].
(Registered ID code input
determination)
6. Determine the input code by pressing
the auto memory button briefly.
7. If it does not match the registered code,
“SR1 Err” is displayed and then it
returns to
“SR1 - - - -”.
8. If it matches the registered code,
“SR1 UNLOCK” appears for 3
seconds which indicates that the code
input has been completed.
9.
“SR1 100” appears which indicates that
the parental lock is off. At this time,
sound is heard.
(How to clear the message)
l Press any of the following FM/AM,
SAT, CD, MEDIA, CAT, ESN/DISP,
Instant replay, POWER buttons.
l Turn the ACC off or insert a CD.
NOTE
l If an ID code is not input for 10 seconds,
“Err” is displayed and it returns to the
former display.
l Channel preset buttons 1, 2, 3, 4 and the
auto memory button are used for input of
the ID code. Buttons 5 and 6 cannot be
used.
Error signs
(1) Depending on the surrounding
conditions (such as large trees,
buildings, or tunnels) and special
weather conditions, the reception of
SIRIUS radio waves may be
decreased or temporarily interrupted.
“ACQUIRING SIGNAL” may
appear.
(2) In case of an antenna malfunction,
“ANTENNA FAIL” is displayed.
Check the satellite radio antenna,
antenna cable and DLP antenna
connector.
NOTE
If a broken DLP* unit is replaced with a new
unit, cancel the license for the broken unit and
make sure to carry out new registration for the
replaced unit. If the license for the broken unit
is not canceled, you will be charged a
reception fee for both units.
* DLP: Down Link Processor
(SATELLITE RADIO Module)
6-44
Interior Comfort
Audio System
RX-8_8Z09-EA-08C_Edition3 Page252
Thursday, July 3 2008 2:23 PM
Form No.8Z09-EA-08C