Memorex MX4122 - Manual (Page 16)

15
Press the Tune/Skip/Search n 1
or o 2 button to select the first
track that you wish to program.
1 2
4
MP3/WMA: If using an
MP3/WMA, you will first select the
album/folder using the FOLDER
UP 1 or DOWN 2 buttons, then
press the PROGRAM/CLOCK
SET button 3 to confirm, then
select the first desired track inside
the album/folder.
5a
When the desired track number
appears in the display, press the
PROGRAM/CLOCK SET button
again.
Repeat steps 4 through 7 until
you have programmed up to 20
track numbers into the CD
Program Memory. When the
memory is full, “FULL” will appear
in the display again.
1
6
After programming up to 20/10 (see note below) tracks in the CD
Program Memory, press the PLAY/PAUSE (®p) button 1 to begin
programmed playback. “MEM” will appear in the display and playback
will begin on the first track that you programmed. The player will
continue to play all of the tracks that you programmed in the order in
which you programmed them. When the last programmed track has
been played, the player will stop and the display will again show the
total number of folders (for MP3/WMA discs only)/tracks/playing time
on the disc. If you press the PLAY/PAUSE (®p) button 1 again,
playback will start on the first track you programmed and will continue
until all the programmed tracks have been played. To clear the
programmed memory and cancel the Programmed Playback mode,
press the STOP (■)/BAND button 2 once while in the Stop mode.
"MEM" will disappear from the display.
1 2
7
Use the Tune/Skip/Search n 1 or
o 2
button and/or the SKIP
TRACKS +10 3/–10 4 buttons to
select the first desired track inside
the album/folder.
NOTE: You can only program 10
tracks when playing a MP3/WMA
disc.
5b
OPERATING INSTRUCTIONS (CONTINUED)
NOTES:
• To check the programmed tracks, while in the Stop mode, press the PROGRAM/CLOCK SET button
repeatedly to view the programmed tracks.
• The CD player in this unit has a 20 or 10 track programmable memory (20 tracks for standard CD, 10
tracks for MP3/WMA CD).