Memorex MX4122 - Manual (Page 5)

4
PREPARATION FOR USE
AC OPERATION
Unwind the AC power cord and extend it to its full length. Insert the AC power cord into any convenient 120V
60Hz household outlet.
Please note that this unit is equipped with a polarized AC plug which
has one blade wider than the other. This is a safety feature to reduce
the likelihood of electric shock. This polarized AC plug will only fit in a
polarized AC outlet. If you find that you cannot insert this plug into your
outlet, you may have an obsolete non-polarized outlet. Please do not
try to defeat this safety feature by using a non-polarized adapter or by
filing the wider blade to make it fit into your outlet. If this plug does not
fit into your outlet, you should contact a qualified licensed electrician to
replace your obsolete outlet.
NOTE: If there is a power failure or the AC cord is disconnected for a short period time, the clock will stop
and the time will be kept. When the power is resumed or the AC cord is connected again, the clock time will
continue running. However, you need to adjust to clock again. If the power failure or the AC cord is
disconnected for several minutes, the clock will be reset (“12:00” will appear in the display) and you will need
to set the clock again.
SPEAKER CONNECTION
1. Place the speakers in convenient locations on either side of the unit.
Usually a distance of five to eight feet between speakers provides the
best stereo effect, but this may vary depending on the size and
acoustics of the room.
2. Locate the Speaker Terminals on the rear of the unit and connect the
dashed black wires to the red (+) terminals and connect the solid black
wires to the black (–) terminals.
3. To connect the speakers, press and hold the terminal down, insert the
speaker wire and release.
4. Pull lightly on the connection to make sure it is secure.
CAUTION: Only connect the speakers which are supplied with the unit. The use of any other or additional
speakers may cause damage to the unit. Never operate the unit without the speakers connected.
REMOTE SENSOR
To operate the unit with the remote control, point the remote at the remote sensor on the front of the main
unit and press the appropriate button. The remote control has an effective operating range of approximately
15 feet and an angle of no more than 30°.
NOTE: Bright sunlight may interfere with the operation of the remote control.
AC Plug
AC Outlet
SPEAKER CONNECTION