1 attaching the base, 2 connecting the cable – MaxTech XT4861 User Manual
Page 4
3
signal is re-enabled the monitor returns to normal operation.
The monitor enters DPMS OFF mode when the computer turns off both the
Horizontal and Vertical Synchronization signals. This mode reduces the
monitor’s power consumption to 3W. When the synchronization signals
are re-enabled the monitor returns to normal operation.
Section 2 - Installation
2.1 Attaching the Base
• Carefully place the monitor on
its side or top.
• Insert the hooks on the swivel
base into the slots in the bot-
tom of the monitor. Push down
and forward on the base until
the it snaps into place.
• Place the display upright in an
appropriate location.
2.2 Connecting the Cable
· Plug the 15-pin male connector on the video cable into the output
COM1
COM2
LPT1
VIDEO
Expansion boards
Figure 2-2 Monitor Connections
Figure 2-1 Connecting the Base