MaxTech XT4861 - Manual (Page 5)

4
connector on the rear of your computer system. The video output
connector on your computer may be either in a location similar to
Figure 2-2
or on an expansion board. Secure the cable to the
computer using the thumbscrews on the 15-pin connector.
· Attach the power cord to the monitor and plug it into an AC outlet.
· The monitor is now ready for use.
Section 3 - Monitor Controls and LEDs
1. Power Indicators: LEDs A and B indicate the state of the Monitor.
•
LED A On (green) Normal operations.
• LED A flashing DPMS “STAND-BY” mode.
• LED B On (orange) DPMS “OFF” mode.
2. Power Switch:Push to turn the monitor ON, push again to turn the
monitor OFF.
3. Trapezoid: Adjusts the angle of the sides of the display to make the
display rectangular.
4. Pincushion Adjusts the curvature of the sides of the display to make
the sides straight.
5. Vertical-Position: Adjusts the vertical position
6. Vertical-Size: Adjusts the display height
7. Horizontal-Position :Adjusts the horizontal position
8. Horizontal-Size: Adjusts the display width.
A
B
1
2
3 8 9 10 7 6 5 4
Figure 3-1 Controls and LEDs