Multiquip CONCRETE SAW FS2 - Manual (Page 10)

PAGE 10 — MQ-WHITEMAN FS2 CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #2 (11/08/01)
GENERAL SAFETY
■ Always read, understand, and follow procedures in Operator’s
Manual before attempting to operate equipment.
■ Always be sure the operator is familiar with proper safety
precautions and operating techniques before using the saw.
■ Stop the engine when leaving the saw unattended.
■ Block the unit when leaving or when using on a slope.
■ Maintain this equipment in a safe operating condition at all
times.
■ Always stop the engine before servicing, adding fuel and oil.
■ NEVER Run engine without air filter. Severe engine damage
may occur.
■ Always service air cleaner frequently to prevent carburetor
malfunction.
■ Always store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■ NEVER use accessories or attachments, which are not
recommended by Multiquip for this equipment. Damage to
the equipment and/or injury to user may result.
■ NEVER operate this saw in areas that contain combustible material
or fumes. Fire and/or explosions may result from errant sparks
from the equipment.
WARNING:
■ DO NOT operate this equipment unless all
guards and safety devices are attached and in
place.
FS2 CONCRETE SAW — RULES FOR SAFE OPERATION
DIAMOND BLADE SAFETY
■ Use appropriate steel centered diamond blades manufactured
for use on concrete saws.
■ Always inspect diamond blades before each use. The blade
should exhibit no cracks, dings, or flaws in the steel centered
core and/or rim. Center (arbor) hole must be undamaged and
true.
■ Examine blade flanges for damage, excessive wear and
cleanliness before mounting blade. Blade should fit snugly on
the shaft and against the inside/outside blade flanges.
■ Ensure that blade is marked with an operating speed greater
than the blade shaft speed of the saw.
■ Only cut the material that is specified by the diamond blade.
Read the specifications of the diamond blade to ensure the proper
tool has been matched to the material being cut.
■ Always keep blade guards in place. Exposure of the diamond
blade must not exceed 180 degrees.
■ Ensure that the diamond blade does not come into contact with
the ground or surface during transportation. DO NOT drop the
diamond blade on ground or surface.
■ The engine governor is designed to permit maximum engine
speed in a no-load condition. Speeds that exceed this limit may
cause the diamond blade to exceed the maximum safe allowable
speed.
■ Ensure that the blade is mounted for proper operating direction.
SAW TRANSPORTATION SAFETY
■ Use the lifting bail and appropriate lifting equipment to ensure
the safe movement of the saw.
■ DO NOT use the handle bars and/or front pointer as lifting points.
■ NEVER tow the saw behind a vehicle.
■ Ensure that both pointer bars are positioned appropriately to
minimize their exposure during transportation.
■ Safeguard against extreme saw attitudes relative to level. Engines
tipped to extreme angles may cause oil to gravitate into the cylinder
head making the engine difficult to start.
■ NEVER transport the saw with the blade mounted.
■ Caution must be exercised while servicing this equipment.
Rotating and moving parts can cause injury if contacted.
■ Keep all inexperienced and unauthorized people away from
the equipment at all times.
■ Unauthorized equipment modifications will void all warranties.
■ Test the ON/OFF switch before operating. The purpose of the
switch is to shut down the engine.