Multiquip CONCRETE SAW FS2 - Manual (Page 23)

MQ-WHITEMAN FS2 CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #2 (11/08/01) — PAGE 23
WARNING
Guards and Covers Check
NEVER operate the saw without blade guards and covers
(Figures 11 and 12) in place. DO NOT operate with the front of
the blade guard raised. The blade exposure cannot exceed 180
degrees during operations. Adhere to the safety guidelines of
the American National Standards Institute (ANSI) B7.1 and
B7.5.
Figure 11. Blade Guard
CHECK the following on the "blade guard":
■ Check to ensure the capacity of the blade guard matches the
diameter of your diamond blade.
■ Check that the guard seats firmly upon the bayonet fitting of
the saw frame.
■ Check that the spring tensioned front cover of the guard is
firmly seated with the rear section of the guard, and there are
no gaps.
■ Check the fit of the water hoses about the two water manifolds
(14" guard). NEVER lift the blade guard while cutting.
■ Check that the flood water tubes and water jets are clear and
open. Test the water supply for pressure and flow (to both
sides of the blade) before sawing operations.
CHECK the following on the "blade flange cover":
■ Check that the flange cover seats firmly upon the bayonet
fitting of the saw frame prior to operation.
■ This flange cover is to be in place when cutting from either the
right or left side of the saw.
Figure 12. Blade Flange Cover
V-belts and Cover
CAUTION:
NEVER attempt to check the V-belt with the engine running
because severe injury can occur. Keep fingers, hands, hair and
clothing away from all moving parts.
V-belts Alignment and Tensioning
This concrete saw is equipped with three premium V-belts that
have been aligned and tensioned by factory personnel. All three
V-belts MUST be installed for proper operation of the saw. Failure
to run the saw with less than three belts may damage the saw or
equipment.
Use the following procedure to check the alignment of V-belts:
1. Remove the 3 bolts that secure the V-belt cover (Figure 13)
to the saw frame.
Figure 13. V-Belt Cover
FS2 CONCRETE SAW — INSPECTION -GUARDS, COVERS AND V-BELTS
Figure 14. V-Belt Parallelism
2. Check uniform parallelism (Figure 14) of V-belts and pulley
(sheaves). Use a straight edge or machinists's square
against both pulleys and adjust both pulleys until equally
aligned.