Miele PROFESSIONAL PG 8050I - Manual (Page 56)

With the aid of the following guide, minor problems can be fixed without a service call.
Repairs should only be carried out by a qualified and trained person in
accordance with local and national safety regulations. Unauthorized repairs
could cause personal injury or machine damage.
Technical faults
Issue Possible fault Solution
The "Start/Stop"
indicator does not flash
after the appliance has
been turned on with the
"On/Off" button. The door is not properly
closed. Close the door firmly.
The appliance is not
plugged in. Insert the plug.
The fuse is defective or
has tripped. Replace the fuse
(see data plate).
The dishwasher stops
during a program. The fuse is defective or
has tripped. Replace the fuse
(see data plate).
The "Fill/Drain"
indicator lights and
flashes alternately. The water supply is
closed. Open the water supply
fully.
The water inlet filter is
blocked. Before fixing the problem:
– Press the "Start/Stop"
button for at least one
second.
– Turn the dishwasher
off.
Then:
– Clean the water inlet
filter, see "Cleaning the
water inlet filter".
The Waterproof system
has reacted. Call the Miele Service
Department.
Frequently asked questions
56