Miele PROFESSIONAL PG 8050I - Manual (Page 70)

Drainage
– The drain hose is equipped with a
non-return valve which prevents
waste water from flowing back into
the machine.
– The machine should preferably be
connected to a separate drainage
system onsite.
If separate drainage is not available
contact your Miele application
specialist for advice.
The onsite drain connection point
should be located between 1 ft.
(0.3 m) and 3’ 3". (1 m) above the
lower edge of the machine.
If it is lower than 1 ft. (0.3 m), bend
the hose in a curve to a height of at
least 1 ft. (0.3 m).
The drainage system must be able to
take a minimum drainage flow of
4.5 gal/min (16 l/min).
– The flexible drain hose is 4’ 7" (1.4 m)
long and has an internal diameter of
7
/
8
" (22 mm). Do not cut the drain
hose.
Hose clamps are supplied for
securing it into position.
– A longer drain hose (up to 13 ft.
[4 m] long) is available from Miele.
– The drainage system must not
exceed 13 ft. (4 meters).
– See the supplied installation
diagram.
Plumbing
70