Monarch Instrument PLT200 User Manual
Page 13
NONE, 1, 2 or 3
OR
Repeat until
desired decimal
places displayed
Unit will remember these settings (including lock on/off) even if turned off
and back on.
OR
Repeat until
desired Units
displayed
DONE, then Units
selected
10
7.
Select Units
8.
Save and
advance
9.
Enter selection
of number of
decimal places
10. Select decimal
places
11. Save and
advance
12. Exit Setup –
Ready to
measure
13
Rotational: C RPS,
C RPM or C RPH
Linear: IPS, IPM, IPH, FT/S, FT/M, FT/H, YPS, YPM,
YPH, MPH, CM/S, CM/M, CM/H, M/SEC, M/MIN, M/H
NONE, 1, 2 or 3
OR
Repeat until
desired decimal
places displayed
OR
Repeat until
desired Units
displayed
8a. Enter
selection of
Wheel
8b. Select
Wheel
8c. Save and
Advance
Only for Linear Units:
Rotational Units Linear Units
OR
OR
Toggles
between 10CM
and 12IN
Last Wheel
selected is
displayed
6.
Enter selection
of Units
7.
Select Units
8.
Save and
advance
9.
Enter selection
of number of
decimal places
10. Select decimal
places
RATE Setup (continued):