Monarch Instrument PLT200 - Manual (Page 9)

Display: 5 x 0.5” (12.7mm) numeric digits plus 5 Alpha-numeric LCD
Batteries: 2 “AA” 1.5 V (DC) alkaline included
(Note: Batteries are NOT rechargeable.)
Battery Life: 30 hours continuous typical with batteries provided
External Input:
Absolute max: -0.3 V to 5 V (DC)
Minimum: low below 1.2 V and high above 2 V (TTL compatible)
Edge: Triggers on Positive edge
Power Out: 3.0 V nominal, approx. 2.8 V @ 20 mA max
Pulse Output: 0 V to 3.3 V (DC) pulse
Same shape as External Input signal or high when internal
optics sees a reflection
Dimensions: 6.92” (17.58 cm) H x 2.4” (6.10 cm) W x 1.6” (4.06 cm) D
Weight: Approx. 7 oz. (210 g)
This product is designed to be safe for indoor use under the following
conditions (per IEC61010-1).
Installation Category II per IEC 664
Pollution Degree Level II per IEC 664
Temperature: 40 °F to 105 °F (5 °C to 40 °C)
Humidity: Maximum relative humidity of 80% for temperatures up
to 88 °F (31 °C) decreasing linearly to 50% relative
humidity at 100 °F (40 °C). Humidity non-condensing.
Specifications subject to change without notice.
6 17
TOTALizer Setup (continued):
NONE, 1, 2 or 3
OR Repeat until
desired decimal
places displayed
Unit will remember these settings (including lock on/off) even if turned off
and back on.
DONE,
then Units selected
DONE,
USE CONTACT TIP or
[wheel selected],
then Units selected
Units = COUNT: Rotational/Linear Units:
9. Enter selection
of number of
decimal places
10. Select decimal
places
11. Save and
advance
12. Exit Setup –
Ready to
measure