Memorex mt2026D - Manual (Page 17)

Tuning in
Press6 button to select START item.
Press 3 or 4 button to start Auto Program .
Press5or 6 button to select
PRESET item.
15
Press MENU button.
Press 3or 4 button to enter
PRESET menu.
To enter the PRESET menu
4
Press 3 or 4 button to enter AUTO PROGRAM sub
menu.
In AIR mode, the set receives antenna
signals. In CABLE mode the set receives
Cable TV programs. Please select:
AIR: If using VHF/UHF antenna.
CABLE: If using Cable TV.
Auto program
3 Highlight ANTENNA item, press 3 or 4 button to select
AIR or CABLE .
1
2
Enter the PRESET menu, highlight AUTO PROGRAM
item.
AUTO PROGRAM
CH SETUP
PRESET
MAIN MENU
PICTURE
P . LOCK
CLOCK
PRESET
EXTRA
ANTENNA
START
AUTO PROGRAM
AIR
When you turn on the TV for the first time, you should perform an
auto program to set up stations on your TV. Below is the steps.
The unit begins to search and memorize all available programs.
Please wait patiently since it will take some time to finish
searching.
Note:
The TV set will first memorize analog programs. After all
available analog programs have been memorized, it begins to
memorize DTV programs. During analog program memorizing,
you can press MENU button to stop it, then the TV turns to
memorize DTV programs. If you want to stop DTV program
memorizing, just press MENU button again.
Menu navigation
button
MENU
Exit the menu