Memorex MX5520SPKA - Manual (Page 2)

IMPORTANT SAFEGUARDS
CAUTION:
_ Read all of these instructions.
_ Save these instructions for later use.
_ Follow all warnings and instructions marked on the audio equipment.
1. READ INSTRUCTIONS
All the safety and operating instructions should be read before the product
is operated.
2. RETAIN INSTRUCTIONS
The safety and operating instructions should be retained for future reference.
3. HEED WARNINGS
All warnings on the product and in the operating instructions should be
adhered to.
4. FOLLOW INSTRUCTIONS
All operating and use instructions should be followed.
5. WATER AND MOISTURE
The product should not be used near water, for example, near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming
pool, etc.
6. CARTS AND STANDS
The product should be used only with a cart or stand that is recommended
by the manufacturer.
6A. An appliance and cart combination should be moved
with care. Quick stops, excessive force, and uneven
surfaces may cause the appliance and cart
combination to overturn.
7. WALL OR CEILING MOUNTING
The product should be mounted to a wall or ceiling as recommended by the
manufacturer.
8. HEAT
The product should be situated away from heat sources such as radiators,
heat registers, stoves, or other products ( including amplifiers ) that produce
heat.
9. VENTILATION
The product should be situated so that its location or position does not
interfere with its proper ventilation. For example, the product should not be
situated on a bed, sofa, rug, or similar surface that may block the ventilation
openings; or, placed in a built-in installation, such as a bookcase or cabinet
that may impede the flow of air through the ventilation openings.
10. POWER SOURCES
The product should be connected to a power supply only of the type
described in the operating instructions or as marked on the product.
11. GROUNDING OR POLARIZATION
Precautions should be taken so that the grounding or polarization means of
a product is not defeated.
12. POWER-CORD PROTECTION
Power-supply cords should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them, paying
particular attention to cords at plugs, convenience receptacles, and the
point where they exit from the product.
13. CLEANING
The product should be cleaned only as recommended by the manufacturer.
14. POWER LINES
An outdoor antenna should be located away from power lines.
15. OUTDOOR ANTENNA GROUNDING
If an outside antenna is connected to the receiver, be sure the antenna
system is grounded so as to provide some protection against voltage
surges an built up static charges. Section 810 of the National Electrical
Code. ANSI/NFPA 70 provides information with respect to proper
grounding of the mast and supporting structure, grounding of the lead-in
wire to an antenna discharge unit, size of grounding conductors, location
of antenna-discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode. See Figure.
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
16. NONUSE PERIODS
The power of the product should be unplugged from the outlet when left
unused for a long period of time.
17. OBJECT AND LIQUID ENTRY
Care should be taken so that objects do not fall and liquids are not spilled
into the enclosure through openings.
18. DAMAGE REQUIRING SERVICE
The product should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged; or
B. Objects have fallen or liquid has been spilled into the product; or
C. The product has been exposed to rain; or
D. The product does not appear to operate normally or exhibits a marked
change in performance; or
E. The product has been dropped, or the enclosure damaged.
19. SERVICING
The user should not attempt to service the product beyond that described
in the operating instructions. All other servicing should be referred to
qualified service personnel.
20. NOTE TO CATV SYSTEM INSTALLER
This reminder is provided to call the CATV system installer s attention to
Article 820-40 of the NEC that provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as
practical.
WARNING:
To reduce the risk of fire or electric shock, do not expose it is
appliance to rain or moisture.
CAUTION:
Use of controls or adjustments or performance of procedures other
than those specified may result in hazardous radiation exposure.
CAUTION
To reduce the risk of electric shock, do not remove cover (or back).
No user serviceable parts inside. Refer servicing to qualified service
personnel
The lightning flash with arrowhead symbol within an equilat-
eral symbol, with an equilateral triangle, is intended to alert
user to the presence of uninsulated dangerous voltage
within the products enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance ( servicing ) instruction in the
literature accompanying the appliance.
CAUTION
For Compact Disc Units only.
INVISIBLE LASER RADIATION WHEN OPEN AND
INTERLOCK FAILED OR DEFEATED.
AVOID DIRECT EXPOSURE TO LASER BEAM.