Manitowoc Ice 14514 2/08 - Manual (Page 18)

Operation Section 3
3-2 Part Number 14514 2/08
Operating Checks and Adjustments
DOOR HINGE ADJUSTMENT
1. Loosen 2 Phillips head screws on the top and
bottom hinges where the hinges fasten to the
cabinet exterior front facing.
2. Firmly press the door tight to the cabinet front while
re-tightening the hinge screws.
NOTE: For some adjustments, it may be necessary to
add shims behind the hinges.
REMOVING DOORS
Remove 2 Phillips head screws from the top door hinge
and 2 Phillips head screws from the bottom hinge.
Carefully lift the door off the cabinet front.
REHINGING DOORS — SINGLE DOOR MODELS
McCall’s one door models are factory-shipped hinged on
the right side (facing the unit front). If it becomes
necessary to change the hinging on a door:
1. Remove 2 Phillips head screws from the top and
bottom door hinges.
2. Carefully lift the door off of the cabinet.
3. Remove the (3) screws securing the door handle
and remove the handle.
4. Turn the door 180 degrees.
5. Attach handle at the position indicated by the pre-
punched mounting holes.
6. Remove the hinges from the door as shown in the
drawing.
7. Position and attach the new hinge
(Part #HAH-0702-001 for the top hinge,
Part #2HAH-0704-001 for the bottom hinge).
8. Remove and reposition the hinge cartridge
mechanism.
9. Attach the door to the cabinet using the screws
removed earlier.
10. Perform the “Door Hinge Adjustment” procedure
above.
Hinge Removal
Hinge Pin
Screw
0302
Hinge Pin
Removable
Mechanism
Hinge Mechanism
Mounting Screws