Manitowoc Ice 14514 2/08 - Manual (Page 9)

Part Number 14514 2/08 2-1
Section 2
Installation Instructions
Please call your local McCall dealer or the McCall
Service Department if you have any questions regarding
proper installation.
Locating the Cabinet
Pre-installation Checklist
NOTE: A fully loaded cabinet can weigh more than
2,000 pounds.
Cabinet Clearances (Typical Single Door Cabinet Shown)
Important
These instructions are of the utmost importance in
assuring that the McCall cabinet operates as
designed. Follow them closely.
! Caution
When selecting a permanent location for the unit,
observe the following guidelines. Failure to do so
may cause reduced performance and efficiency,
cause damage, and/or void your warranty.
Install the cabinet in an indoor environment
only.
The air temperature entering the refrigerator or
freezer condenser should be between 55°F
(13°C) and 100°F (38°C).
Allow space for air circulation in the refrigeration
condensing unit compartment on refrigerators
and freezers. The minimum space requirements
are shown below.
The floor must be strong enough to support the
weight of the cabinet and product load.
PIZZA TABLES AND
REFRIGERATED BASES
E-3045-B
CHEF STANDS
COMPACT UNDERCOUNTERS
REFRIGERATOR AND FREEZERS
Front View
Side View 6.00"
(15.2 cm)
(Load Height)
Front View Side View Front View Side View
6.00"
(15.2 cm)
(Load Height)
6.00"
(15.2 cm)
(Load Height)
1.00"
(2.5 cm)
Line
Cover
3.00"
(7.6 cm)
6.00"
(15.2 cm)
1.00"
(2.5 cm)
Note:
1" side clearance
is recommended
on 27" and 45"
freezers.
No side clearance
is needed on
refrigerators.
1.00"
(2.5 cm)