Motorola BR700 - Manual (Page 54)

CONFIGURATION SECTION 3
SECTION 3, CONFIGURATION 3-23
Field Description
UDP Session Idle
Time User Datagram Protocol. A method used along
with the IP to send data in the form of message
units (datagram) between network devices
over a LAN or WAN. Used primarily for
broadcasting messages over a network. The
default is 8 hours.
ICMP Session Idle
Time The Internet Control Message Protocol is a
protocol used for error, problem, and
informational messages sent between IP hosts
and gateways. The default is 5 minutes.
Networking - Port Trigger
When you run a PC application that accesses the Internet, it typically
initiates communications with a computer on the Internet. In some
applications, especially gaming, the computer on the Internet also
initiates communications with your PC. Because NAT does not
normally allow these incoming connections to occur, the BR700
supports port triggering.
The BR700 is configured with port triggering for some common
applications. You can also configure additional port triggers if
needed. Configuring port triggers for an application requires a Port
Trigger entry, explained below.