Philips Magnavox MDV540VR - Manual (Page 17)

First-time DVD/VCR Setup 17
3 Press o or p to select English, French, or Spanish as
the language for VCR on-screen displays and menus. Then,
press B.
4 Press B to begin channel programming. AUTO
SETUP will flash on the TV screen during the channel
search.The DVD/VCR will memorize all available channels.
When channel programming is complete, the lowest avail-
able channel will appear on the TV.
These channels will be available when you want to watch
TV while in VCR mode.To put the DVD/VCR in VCR
mode, press VCR so the VCR light appears. Use the NEXT
∑/CH o or PREVw/CH p buttons to select memorized
channels.To select non-memorized channels, use the
Number buttons.
• To skip this feature and play a tape
immediately, insert a tape with its
record tab removed.
• To skip step 3, press DISC/MENU.
VCR menus and displays will be in
English.
• If you try to program channels
when there is no antenna or Cable
TV signal connected to the ANT-IN
jack of the DVD/VCR, programming
will stop. AUTO SET UP will stop
flashing. Connect an antenna or
Cable TV signal to the DVD/VCR’s
ANT-IN jack and press B again.
• Repeat this process if the power
fails.
• To stop the Channel Setup while
AUTO SET UP is flashing, press
DISC/MENU.
Helpful Hints
Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
You cannot program channels if you are using a Cable Box or a
Satellite Receiver.
These menus may not appear if you have already turned
on the DVD/VCR.
1 Turn on the TV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel, depending on how you con-
nected the DVD/VCR to a TV.
2 Press VCR, then press STANDBY-ON. The VCR light
will appear on the front of the DVD/VCR.The display shown
below will appear.
These menus may not appear if you have already turned on
the DVD/VCR.You may have turned on the DVD/VCR
before to find the Audio/Video In channel of the TV, for
example. If so, follow the steps on page 26 to set up chan-
nels and page 30 to select a language for the VCR menus.
1
Turn on the TV.
AUTO SET UP
PUSH B
2
LANGUAGE SELECT
B ENGLISH [ON]
FRANCAIS
ESPAÑOL
PUSH B
TIMER SET
SETUP SUBTITLE AUDIO
MODE
DISPLAY
TITLE
PREV/
CH
NEXT/
CH
RETURN
A-B
DVD
PLAY STOP
SEARCH
FF
PAUSE
SPEED NA508
SEARCH
REW
VCR
DISC
REPEAT
C-RESET
CLEAR
REC REPEAT
ANGLE
STANDBY-ON
2 3 1
SLOW
5 6 4
8 9 7
SEARCH MODE ZOOM
0 +10
MENU OK 3-4
H9660UD_1.qx4 04.4.14 4:47 PM Page 17