Micro Star Computer MS- 9130 v1.x - Manual (Page 17)

2-4
MS-9130 Workstation Mainboard
1. Make sure that the computer
is turned off, and the power
cord disconnected before in-
stalling the CPU.
2. Pull the lever sideways away
from the socket, and raise it up
to a 90-degree angle.
3. Locate the cut edge of the
CPU. When the CPU is in-
stalled into the socket, this cut
edge should be aligned with
the corner marking an arrow on
the Socket 940.
Please note that the CPU can
only fit in a correct orientation,
DO NOT use force to install
the CPU into the socket.
4. Place the CPU onto the socket
and press it down firmly into
the socket. The pins of the
CPU should be embedded into
the socket completely.
5. Close the lever to secure the
CPU. Do not close the level
until the CPU’s pins are fully
inserted; otherwise, the pins
may be damaged.
CPU Installation Procedures for Socket 940
X O
Open Lever
Slid
ing
Pla
te
Close
Lever
Press down
the CPU
Cut edge
Corner marking
an arrow