MITSUBISHI ELECTRIC FC810 - Manual (Page 27)

      
     
 
    
      
   
MITSUBISHI ELECTRIC MOTHERBOARD DIVISION PAGE 27 OF 45
 '
Minus (-) or F5 Select the previous value for the current field.
Enter Make a selection from the menu bar or enter a sub-menu.
Home or End Move the cursor to the top or bottom of the current menu.
Page up or Page down Move the cursor to the next or previous page of the current menu.
F9 Restore the default settings for the fields on the current menu.
F10 Save the changes you’ve made and exit from BIOS Setup.
Caution
The default BIOS settings may not be appropriate for your particular system. Make a note of
the current settings before pressing
F 9 or using the Load Setup Defaults option of the Exit
menu.
2  , 
!% 
You can at any time get general help about the control keys by pressing the F 1 key.
The help window on the right-hand side of each menu displays help text for the currently-
selected field. It changes as you move the cursor from one field to another.

 

Immediately after the first screen, a second screen displays various POST messages such as the
memory test. While this screen is on display, a message at the bottom says: ‘
Press <F2> to
enter setup ’. Even if this message is not displayed, you can press the <ESC> key and this
menu will appear just before booting:
This menu can be used to temporarily use another drive or device to boot your system, for
example a bootable CD-ROM, without having to enter the BIOS setup. Simply use the up and
down arrows to make a selection. This change will not be permanent and the system boot will
revert to the normal BIOS setting the next time you switch on your system.
Boot Menu
1. Diskette Drive
2. Removable Devices
3. Hard Disk Drive
4. ATAPI CD-ROM Drive
5. Network Boot
< Enter Setup>