MITSUBISHI ELECTRIC FC810 - Manual (Page 9)

      
     
 
    
      
   
MITSUBISHI ELECTRIC MOTHERBOARD DIVISION PAGE 9 OF 45





Form factor microATX, 9.6" wide x 7.8" deep. ATX 2.01 compliant.
Processor Socket370 with the VRM8.2 regulator on motherboard.
Accepts 66/100Mhz Celeron™ processors
Core logic Intel 810
Cache L2 cache included on processor module.
Memory –
RAM Memory sockets accept 168 pin un-buffered PC100 SDRAM modules.
Memory -
Flash ROM 4Mb Firmware Hub
Buses 4 PCI bus master slots
VGA Integrated Graphics controller (82810) with 2D/3D acceleration, 230Mhz
RAMDAC and optional 4Mb Display Cache (82810-DC100)
Audio –
controller AC’97 2.1 compliant CODEC (Optional)
Hard Disk &
CD-ROM Dual UltraATA33 interfaces for hard disk and CD-ROM. (UltraATA66
optional with ICH1 fitted)
Floppy Disk 720kB, 1.2MB (3-mode), 1.44MB 3½ drives, 1.2MB 5¼ drives.
Support for 120MB drives via ATA port.
Parallel Port IEEE 1284 (ECP & standard) on 25-way D-type
Serial Ports Single 16550. One 9-way D-types on rear edge of motherboard.
USB Two ports.
Ethernet 1x RJ45 port
Keyboard &
Mouse PS/2-style connectors.
Security Chassis intrusion detection.
Power
Management Green and deep green via system management mode.
ACPI compatible.
Wake-on LAN
Standby option with wake-up on interrupt, serial port activity or button.
System
Management Hardware monitoring – Fan monitor (standard), Voltage/ Thermal monitor
(optional - PC87366 I/O)
Plug & Play PC98 and PC99 compliant
Battery back-
up On-board lithium coin cell with 5 years typical life.
PCB 4-layer microATX form-factor.
All components on top side